Minimum Design Loads For Buildings And Other Structures

Standard ASCE/SEI 7-05 provides requirements for general structural design and the means for determining dead, live, soil, flood, wind, snow, rain, atmospheric ice, and earthquake loads, as well as their combinations.

Includes significant changes to the following sections: general provisions, load combinations, live loads, flood loads, wind loads, snow loads, earthquake loads and atmospheric ice loads.

Standard ASCE/SEI 7-22 provides requirements for general structural design and includes means for determining various loads and their combinations, which are suitable for inclusion in building codes and other documents.

ASCE standard, Minimum Design Loads for Buildings and Other Structures, (ASCE 7-93 a revision of ANSI/ASCE 7-88), gives requirements for dead, live, soil, wind, snow, rain, and earthquake loads, and their combinations, that are suitable for inclusion in building codes and other documents. The major revision of this standard involves the section on earthquake loads. This section has been greatly expanded to include the latest information in the field of earthquake engineering. Based on this information criteria for the design and construction of buildings and similar structures subject to earthquake ground motions are presented. The basis of the requirement is described in the Commentary. The structural load requirements provided by this standard are intended for use by architects, structural engineers, and those engaged in preparing and administering local building codes.

Prepared by the Design Loads on Structures during Construction Standards Committee of the Codes and Standards Activities Division of the Structural Engineering Institute of ASCE Design loads during construction must account for the often short duration of loading and for the variability of temporary loads. Many elements of the completed structure that provide strength, stiffness, stability, or continuity may not be present during construction. Design Loads on Structures during Construction, ASCE/SEI 37-14, describes the minimum design requirements for construction loads, load combinations, and load factors affecting buildings and other structures that are under construction. It addresses partially completed structures as well as temporary support and access structures used during construction. The loads specified are suitable for use either with strength design criteria, such as ultimate strength design (USD) and load and resistance factor design (LRFD), or with allowable stress design (ASD) criteria. The loads are applicable to all conventional construction methods. Topics include: load factors and load combinations; dead and live loads; construction loads; lateral earth pressure; and environmental loads. Of particular note, the environmental load provisions have been aligned with those of Minimum Design Loads for Buildings and Other Structures, ASCE/SEI 7-10. Because ASCE/SEI 7-10 does not address loads during construction, the environmental loads in this standard were adjusted for the duration of the construction period. This new edition of Standard 37 prescribes loads based on probabilistic analysis, observation of construction practices, and expert opinions. Embracing comments, recommendations, and experiences that have evolved since the original 2002 edition, this standard serves structural engineers, construction engineers, design professionals, code officials, and building owners.

ASCE 7 is the US standard for identifying minimum design loads for buildings and other structures. ASCE 7 covers many load types, of which wind is one. The purpose of this book is to provide structural and architectural engineers with the practical state-of-the-art knowledge and tools needed for designing and retrofitting buildings for wind loads. The book will also cover wind-induced loss estimation. This new edition include a guide to the thoroughly revised, 2010 version of the ASCE 7 Standard provisions for wind loads; incorporate major advances achieved in recent years in the design of tall buildings for wind; present material on retrofitting and loss estimation; and improve the presentation of the material to increase its usefulness to structural engineers. Key features: New focus on tall buildings helps make the analysis and design guidance easier and less complex. Covers the new simplified design methods of ASCE 7-10, guiding designers to clearly understand the spirit and letter of the provisions and use the design methods with confidence and ease. Includes new coverage of retrofitting for wind load resistance and loss estimation from hurricane winds. Thoroughly revised and updated to conform with current practice and research.

ASCE/SEI 49-21 provides the minimum requirements for conducting and interpreting wind tunnel tests to determine wind loads on buildings and other structures.