Aerodynamic Characteristics Of A Wing With Quarter Chord Line Swept Back 45 Degrees Aspect Ratio 4 Taper Ratio 0 3 And Naca 65a006 Airfoil Section

This paper presents the results of the investigation of a wing-alone and wing-fuselage configuration employing a wing with the quarter-chord line swept back 45 degrees, with aspect ratio 4, taper ratio 0.3, and an NACA 65A006 airfoil section. Lift, drag, pitching moment, and root bending moment were obtained for these configurations. In addition, effective downwash angles and dynamic-pressure characteristics in the region of a probable tail location were also obtained for these configurations and are presented for a range of tail heights at one tail length. In order to expedite the publishing of these data, only a brief analysis is included.

This paper presents the results of the investigation of wing-alone and wing-fuselage combination employing a delta wing having 45 degree sweepback of the leading edge, aspect ratio 4, and an NACA 65A006 airfoil section. Lift, drag, pitching moment, and root bending moment were obtained for these configurations. In addition, effective downwash angles and dynamic-pressure characteristics in the region of a probable tail location also were obtained for these configurations, and are presented for a range of tail heights at one tail length. In order to expedite publishing of these data, only a brief analysis is included.

This paper presents the results of an investigation to determine the control-effectiveness characteristics of 30-percent-chord flap-type control surfaces of various spans on a semispan wing-fuselage model. The wing of the mode had 35 degrees of sweepback of the quarter chord, an aspect ratio of 4.0, a taper ratio of 0.6, and an NACA 65A006 airfoil section parallel to the free stream. Lift, rolling moments, and pitching moments were obtained for several angle of attack throughout a small range of control-surface deflections. Most of the data are presented as control-effectiveness parameters which show their variation with Mach number.

An investigation has been conducted in the Langley 4- by 4-foot supersonic pressure tunnel to determine the effects of wing and horizontal-tail vertical location on the aerodynamic characteristics in sideslip at various angles of attack for a supersonic airplane configuration at Mach numbers of 1.41 and 2.01. The basic model was equipped with a wing and horizontal tail, each having 45 degree sweep and an aspect ratio of 4. The wing had a taper ratio of 0.2 and NACA 65A004 sections; the horizontal tail had a taper ratio of 0.4 and NACA 65A006 sections.

An investigation at transonic speeds of the loading over a 45 degree sweptback wing having an aspect ratio of 3, a taper ratio of 0.2, and NACA 65A004 airfoil sections has been conducted in the Langley16-foot transonic tunnel. Pressure measurements on the wing-body combination were obtained at angles of attack from 0 to 26 degrees at Mach numbers from 0.80 to 0.98 and from 0 to about 12 degrees at Mach numbers from 1.00 to 1.05. Reynolds number, based on the wing mean aerodynamic chord, varied from 7,000,000 to 8,500,000 over the test Mach number range.