Biodeterioration Investigation Techniques

Man-made textile fibers are frequently encountered as trace evidence in criminal investigations. This study examined the effects of burial in soil on the biodeterioration of synthetic textile fibers such as cellulose acetate, nylon, polyesters and acrylics. Cellulose acetate fibers began to show signs of decomposition within two months after burial in common garden topsoil and were completely degraded within four to nine months. It was found that severely decomposed cellulose acetate fibers could be identified by pyrolysis-gas liquid chromatography even when other methods such as polarized light microscopy and dispersion staining failed. The solubility behavior of the cellulose acetate fibers also was altered. The other types of fibers showed no detectable alteration at the end of the twelve-month study. REFERENCES American Association of Textile Chemists and Colorists (1971). AATCC Technical Manual, AATCC, Triangle Park, NC. Cook, R., and Paterson, M.D. (1978). New techniques for the identifi- tion of microscopic samples of textile fibers by infrared spectroscopy. Forensic Sci. Int., 12, 237-243. DeForest, P.R., Geansslen, R.E., and Lee, H.C. (1983). Forensic Science: An Introduction to Criminalistics, McGraw-Hill Book Company, NY. Federal Bureau of Investigation (1978). Solubility schemes by generic class. Federal Bureau of Investigation, Washington, DC. Fong, W. (1982). Rapid microscopic identification of synthetic fibers in a single liquid mount. ~ Forensic Sci., 27, 257-263.

Because of the magnificent response to the call for papers for the 7th International Biodeterioration Symposium held at Cambridge, UK, some difficulties have been experienced in the editing of these proceedings. The numbers of papers submitted exceeded expectation and because of this it has been necessary to accommodate those not actually in the proceedings into the International Biodeterioration journal. A small number of papers were not suitable for publication and were therefore eliminated. Many authors disregarded the guidelines laid down for the length of submitted papers. However, every attempt has been made to accommodate the maximum number of contributions in the proceedings. The original selection included those which most nearly conformed to the length requirement. Even so this has meant, in many cases, cutting down the text, eliminating tables and/or illustrations and pruning the reference list. When references have been trimmed a note has been included to the effect that an extended list may be obtained from the author/senior author. Where it was not possible to carry out these procedures without seriously altering the text and the import of the paper they have been included amongst those to be published in the journal International Biodeterioration. The exceptions to the procedures outlined above are the invited review papers which have been presented in full. Happily, the authors have been conscientious in keeping to the guidelines laid down for these contributions.

First Published in 1986, this two-volume set offers comprehensive insight into the testing of toxic substances using microorganisms as reference. Carefully compiled and filled with a vast repertoire of notes, diagrams, and references this book serves as a useful reference for students of medicine and other practitioners in their respective fields.

Sample Text

This unique and comprehensive text considers all aspects of heat exchanger fouling from the basic science of how surfaces become fouled to very practical ways of mitigating the problem and from mathematical modelling of different fouling mechanisms to practical methods of heat exchanger cleaning. The problems that restrict the efficient operation of equipment are described and the costs, some of them hidden costs, that are associated with the fouling of heat exchangers are discussed. Some simple concepts and models of the fouling processes are presented as part of the introduction to the subject. Advice on the selection, design, installation and commissioning of heat exchangers to minimise fouling is given. A large part of the text is devoted to the use of chemical and other additives to reduce or eliminate the problem of fouling. Another large section is designed to give information on both on-line and off-line cleaning of heat exchangers. One of the difficulties faced by designers and operators of heat exchangers is anticipating the likely extent of fouling problems to be encountered with different flow streams. Another large section addresses the question and describes methods that have been used in attempting to define fouling potential. The book concludes with a chapter on how fouling information can be obtained using plant data, field tests and laboratory studies.

This Springer Handbook of Metrology and Testing presents the principles of Metrology – the science of measurement – and the methods and techniques of Testing – determining the characteristics of a given product – as they apply to chemical and microstructural analysis, and to the measurement and testing of materials properties and performance, including modelling and simulation. The principal motivation for this Handbook stems from the increasing demands of technology for measurement results that can be used globally. Measurements within a local laboratory or manufacturing facility must be able to be reproduced accurately anywhere in the world. The book integrates knowledge from basic sciences and engineering disciplines, compiled by experts from internationally known metrology and testing institutions, and academe, as well as from industry, and conformity-assessment and accreditation bodies. The Commission of the European Union has expressed this as there is no science without measurements, no quality without testing, and no global markets without standards.

Man-made textile fibers are frequently encountered as trace evidence in criminal investigations. This study examined the effects of burial in soil on the biodeterioration of synthetic textile fibers such as cellulose acetate, nylon, polyesters and acrylics. Cellulose acetate fibers began to show signs of decomposition within two months after burial in common garden topsoil and were completely degraded within four to nine months. It was found that severely decomposed cellulose acetate fibers could be identified by pyrolysis-gas liquid chromatography even when other methods such as polarized light microscopy and dispersion staining failed. The solubility behavior of the cellulose acetate fibers also was altered. The other types of fibers showed no detectable alteration at the end of the twelve-month study. REFERENCES American Association of Textile Chemists and Colorists (1971). AATCC Technical Manual, AATCC, Triangle Park, NC. Cook, R., and Paterson, M.D. (1978). New techniques for the identifi- tion of microscopic samples of textile fibers by infrared spectroscopy. Forensic Sci. Int., 12, 237-243. DeForest, P.R., Geansslen, R.E., and Lee, H.C. (1983). Forensic Science: An Introduction to Criminalistics, McGraw-Hill Book Company, NY. Federal Bureau of Investigation (1978). Solubility schemes by generic class. Federal Bureau of Investigation, Washington, DC. Fong, W. (1982). Rapid microscopic identification of synthetic fibers in a single liquid mount. ~ Forensic Sci., 27, 257-263.