Gb T 11363 2008 Translated English Of Chinese Standard Gbt 11363 2008 Gb T11363 2008 Gbt11363 2008

This Standard specifies the conventional tensile and shear test methods for brazed/soldered joints. This Standard applies to the determination of the strength of brazed/soldered joints of metallic materials. Other structural materials such as ceramics and composites may also refer to this Standard.

This Part of GB/T 19363.1 specifies the translation services - translation services specifications. This Part is applicable to translation services.

This Standard specifies the method principle, apparatus, sampling and sample preparation, test procedures, results calculation and precision etc. of the coke with particle size greater than 60mm and 25mm. This Standard is applicable to the determination of mechanical strength of coke with particle size no less than 25mm. The coke with particle size less than 25mm can also refer to this Standard.

This standard specifies the method for measuring the tap density, that is, the powder in the container is tapped under certain conditions. Use a tapping apparatus to tap the specified amount of powder in the container until the volume of the powder cannot be further decreased. The mass of the powder divided by the volume is the tap density.

This Standard specifies order content, dimension, shape, weight, technical requirements, test methods, test rules, packaging, marking and quality certificate of seamless steel tubes for liquid service.

This Standard specifies cold forming steel sections in terms of order, classification and code, dimension, shape, weight and permissible deviation, technical requirements, test method, acceptance rules and packaging, marking and quality certificate.

This standard specifies general specifications for acceptance, packaging, marking and certification for section steel (steel bar and rod). This Standard is applicable to hot rolling, cold drawing (rolling), forging and heat treating section steel.

This Standard specifies the terms and definitions used in the field of adhesives. This Standard may be used by relevant departments in domestic and international technical and business exchanges. When formulating and revising standards and compiling technical documents and books, if relevant terminology is used, it shall be implemented in accordance with the provisions of this Standard.