Gb T 15254 2014 Translated English Of Chinese Standard Gbt 15254 2014 Gb T15254 2014 Gbt15254 2014

This standard specifies the 180-degree peel test method for vulcanized rubber as bonded to metal. This standard is applicable to the determination of the 180 peel strength of vulcanized rubber as bonded to metal. The 180-degree peel strength of other flexible materials as bonded to rigid materials may also refer to this standard. This standard does not apply to low-flexibility materials which will produce cracks or delamination after bending 180. Such materials may be subjected to a 90 peel test, the test method may refer to GB/T 7760.

This standard specifies the terms and definitions, method summary, reagents and materials, instruments and equipment, specimens, test procedures, expression of results, method precision of Audibert-Arnu dilatometer test of bituminous coal. This standard applies to bituminous coal.

This Standard specifies contents such as the structure, bar code character set, bar code symbol dimension, quality assurance of GS1 system code 128 (hereinafter referred to as GS1-128 code), and the application parameters, character string encoding and decoding rules of GS1-128 code. This Standard applies to automatic identification and data collection in the bar code system for commodity.

This Part of GB/T 6324 specifies the instrument method that adopts the principle that was determined by International Commission on Illumination (CIE) in 1931, using X, Y, Z (tristimulus values) to express the color of clear liquid to determine the color (expressed in platinum-cobalt color). This Part is applicable to determine clarified, non-turbid liquid organic chemical products of which the nominal platinum-cobalt color number is 0~100 and the sample has similar absorption characteristics to the platinum-cobalt solution, without fluorescence emission.

This Standard specifies the basic design requirements, technical requirements, manufacture and installation, and test methods for the strops with no more than 4 passengers. This Standard is applicable to the design, manufacture, installation and testing of the strops.

This Standard specifies a method for the determination of the indentation hardness of plastics and ebonite by means of durometers of two types: type A is used for softer materials and type D for harder materials (see the Note to 8.2). The method permits measurement either of the initial indentation or of the indentation after a specified period of time, or both.

This standard specifies the test method for the thickness of pressure-sensitive adhesive tapes and other adhesive tapes. This standard applies to the determination of the thickness of adhesive tape. It is used for quality control of adhesive tape products.

This standard specifies the designations, code and chemical composition, and chemical composition analysis methods for the casting titanium and titanium alloys.